[olmaxusa]

Can anyone help me find the diagram with measurements that show exactly where to place the M-Logos on the front fenders (driver and passenger side)?

For those in Canda or Europe, could you send pictures of the M-Logos with measuring tape from the bottom and side fender (driver and passenger side)?

I would greatly appreciate the help.

[Ravenous666]

I can make a picture and measure from the edges as soon as my M50 arrives. Should be within the next 10 days.

[olmaxusa]

Originally Posted by Ravenous666

I can make a picture and measure from the edges as soon as my M50 arrives. Should be within the next 10 days.

Thank you very much!

[MidnightLight]

Out of curiosity... what do you intend to do with this information?

[l33v0nix]

likely to change blackout badge or i think US does not put the fender badge

[ModernAngel]

Originally Posted by l33v0nix

likely to change blackout badge or i think US does not put the fender badge

Yeah, no fender badges in US.

[JoeyO]

Just install it upside down. That will get people’s attention. :-)

[ColVSC]

Here is where I plan on placing mine after the Xpel PPF is installed.

[olmaxusa]

Originally Posted by ColVSC

Here is where I plan on placing mine after the Xpel PPF is installed.

Thank you

[olmaxusa]

Originally Posted by l33v0nix

likely to change blackout badge or i think US does not put the fender badge

Yes, unfortunately the US model does not attach the fender badges…

[olmaxusa]

[QUOTE=Ravenous666;31763830]I can make a picture and measure from the edges as soon as my M50 arrives. Should be within the next 10 days.

Did you recieve your M50?
If so, please make a picture of the fender M badges and measure them from the edges. I would greatly appreciate it.

[Ravenous666]

Will do it tomorrow. Thank you for the patience.

[Ravenous666]

So I'm back from work and made the measurement.

The aft edge of the badge is 100mm from the gap to the door
The lower edge of the badge is 550mm from the lower gap of the fender.

[olmaxusa]

Originally Posted by Ravenous666

So I'm back from work and made the measurement.

The aft edge of the badge is 100mm from the gap to the door
The lower edge of the badge is 550mm from the lower gap of the fender.

Thank you for your help!

[TanziniteG45]

Anyone have the part number for that badge, ideally in black? I got the US model and that fender badge looks nice

[Ravenous666]

Click the link in my signature

[olmaxusa]

Originally Posted by TanziniteG45

Anyone have the part number for that badge, ideally in black? I got the US model and that fender badge looks nice

[TanziniteG45]

Oh, it's the same as the one on the grill. Thanks

[Ravenous666]

Originally Posted by TanziniteG45

Oh, it's the same as the one on the grill. Thanks

No, it's not. The one on the grill is smaller.

See signature for collection of partnumbers.

[TanziniteG45]

I feel like a boomer but I don't see your signature. But I have that thread pulled up so I know the post you're talking about. You've made my life so much easier with your posts!


Correction, you saved me again. I was about to try to apply the fender badge on my grill!

[Ravenous666]

Just to clarify.

The ones on the fenders are 55mm
The one on the grill is 45mm

M Logo small on Fender black 51145A4B373
M-Logo on M50 grill black 45mmx15mm 51145A4B372